Hi
New to this forum, looking forward to hang around and hopefully being able to contribute
Bought a Kobo Glo HD and installed the patch for the nightmode. But it doesn't seem to work accordingly. Have browsed older threads, but couldn't find a solution.
I used the .tgz file from the H20 build, since I couldn't find any Brightness section in the nightmode.ini file after installing the .tgz file from the build13 patch.
[brightness]
1percentPatch = yes
timeout = 4
0 = toggleNightMode
After rebooting the Glo, it's possible to togge to nightmode by dragging the light slider to 0 %. The strange thing is that even though I set timeout to 4 s, it toggle to nightmode even without holding on to the slider during 4s. :blink:
The main problem with this is that I can't turn the frontlight off and keep the daymode, since it's change to nightmode even with not holding the slider on 0% for 4s. :(
Have I missed something? If I set timeout 4s, should I not have to hold on to the slider for 4s for it to toggle into nightmode? And if I don't hold on for 4 s, then it just turns off the frontlight but stays in daymode?
I don't want to use 100%, since it would cause the 100% brightness to irritate my girlfriend when dragging the slider to 100% in bed. Even I get a little irritated by the heavy light until it switch to nightmode. And using any other fixed number is difficult to achive with the slider and could also accidently toggle into nightmode.
Is there a way to use 0% (or whatever number) but with mandatory holding the slider for e.g. 4s to enabling the toggling into nightmode? So when I just want to continue daymode and turn off the frontlight, I then just slide it to 0% and release the slider immediately instead of holding it for e.g. 4 s to toggle into nightmode. :chinscratch:
Hope you understand my somewhat strange English...
New to this forum, looking forward to hang around and hopefully being able to contribute
Bought a Kobo Glo HD and installed the patch for the nightmode. But it doesn't seem to work accordingly. Have browsed older threads, but couldn't find a solution.
I used the .tgz file from the H20 build, since I couldn't find any Brightness section in the nightmode.ini file after installing the .tgz file from the build13 patch.
[brightness]
1percentPatch = yes
timeout = 4
0 = toggleNightMode
After rebooting the Glo, it's possible to togge to nightmode by dragging the light slider to 0 %. The strange thing is that even though I set timeout to 4 s, it toggle to nightmode even without holding on to the slider during 4s. :blink:
The main problem with this is that I can't turn the frontlight off and keep the daymode, since it's change to nightmode even with not holding the slider on 0% for 4s. :(
Have I missed something? If I set timeout 4s, should I not have to hold on to the slider for 4s for it to toggle into nightmode? And if I don't hold on for 4 s, then it just turns off the frontlight but stays in daymode?
I don't want to use 100%, since it would cause the 100% brightness to irritate my girlfriend when dragging the slider to 100% in bed. Even I get a little irritated by the heavy light until it switch to nightmode. And using any other fixed number is difficult to achive with the slider and could also accidently toggle into nightmode.
Is there a way to use 0% (or whatever number) but with mandatory holding the slider for e.g. 4s to enabling the toggling into nightmode? So when I just want to continue daymode and turn off the frontlight, I then just slide it to 0% and release the slider immediately instead of holding it for e.g. 4 s to toggle into nightmode. :chinscratch:
Hope you understand my somewhat strange English...